Surface Preparation:

• Ensure the surface is structurally sound, clean, and free from contaminants, including dirt, oil, curing compounds, and old coatings. New concrete and masonry should be cured for a minimum of 7 days.
• Remove any active water leaks before applying DRYBASE using CP-MoyaProof Plug.

Mixing:

• Mix the entire bag of DRYBASE with 2.4L – 2.5L of clean water for brush or trowel applications. For spray applications, use the same water quantity and mix for at least 3 minutes.

Application:

• Apply DRYBASE from bottom to top, ensuring that all cavities are filled.
• For a second coat, apply it while the first coat is still “green” (2-4 hours after the first coat).
• Brush or Trowel: Apply the material well into the substrate, ensuring adhesion and filling any surface defects.
• Spray: Use a hopper gun with an air pressure of approximately 73 psi and a nozzle diameter of ¼”. Spray the material in a circular motion at a 90º angle to the surface, followed by trowelling or brushing it into the substrate.
• For best results, ensure proper curing and protection from rain and frost for at least 5 days.

Curing and Protection:

• Wet cure the applied material for a minimum of 5 days, using wet spraying or covering with polyethylene sheeting, wet burlap, or similar methods.